In short
Approved products come in defined strengths with matched devices. Compounded preparations do not: concentrations vary between pharmacies, syringes are marked.
By Alsen Walker · Updated September 20, 2026
Approved products come in defined strengths with matched devices. Compounded preparations do not: concentrations vary between pharmacies, syringes are marked in insulin units rather than milligrams, and instructions from one source can be badly wrong for a product from another. This is the single most dangerous practical difference, and it has caused tenfold overdoses.
This page does not tell you how to convert units, and you should not take conversion instructions from any website, forum or seller. The correct figure depends on the concentration of the specific vial in front of you, and getting it wrong by one decimal place means ten times the intended dose.
If you think you have taken too much, contact a poison centre or seek urgent care, particularly with persistent vomiting, severe abdominal pain, or signs of low blood sugar.
For the wider picture on compounded products and how to check a supplier, see Compounded GLP-1s: What They Are and How to Check a Supplier.
Why the problem exists
An approved pen is engineered so the dose is set by the device. Almost nothing depends on your arithmetic.
A compounded vial puts the measurement in your hands. You draw a volume, and how much drug that volume contains depends entirely on the concentration of that particular preparation.
Since concentrations are not standardised across compounders, two vials labelled with the same drug can require completely different volumes for the same dose.
The units mismatch
These medications are dosed in milligrams. The syringes most people can obtain are marked in insulin units, because that is what insulin syringes are for.
Insulin units and milligrams measure different things. There is no fixed relationship between a marking on that syringe and a milligram of any GLP-1 preparation.
Any conversion depends on the concentration, which is why instructions copied from a forum, from a previous vial, or from a different pharmacy can be wrong by a large factor.
Where errors actually come from
Applying instructions written for a different concentration.
A decimal point misread or miswritten, which produces a tenfold error rather than a small one.
Assuming a new vial matches the previous one when the pharmacy or batch has changed.
Verbal or messaged instructions with no written record to check against.
Switching between products and carrying over the old figures.
What a legitimate supplier provides
A pharmacy label stating the drug, the concentration and your name.
Written dosing instructions specific to that preparation, from a named prescriber.
The correct syringe for the volumes involved, with an explanation of which markings to use.
A contactable prescriber or pharmacist to ask.
If you have none of these, you are being asked to perform a calculation nobody has taken responsibility for.
If you are using a compounded product
Get the concentration in writing and check it every time a new vial arrives.
Ask the prescribing clinician or the pharmacist to confirm the volume for your dose with that specific concentration. Ask them to write it down.
Do not carry instructions across from a previous vial, a different pharmacy, or another product.
Do not accept dosing guidance from a seller’s website or a community forum.
Switching to an approved product
Not a dose-for-dose transfer, since the presentations differ. Your prescriber decides where you start.
Tell them exactly what you have been taking, including concentration if you know it, since guessing at your current exposure makes their job harder.
This is the same arithmetic problem described in microdosing and unit confusion, and it is why no figures appear on either page. What a legitimate supplier provides is set out in verifying a pharmacy.
Frequently asked questions
How many units equal a milligram?
There is no general answer. It depends on the concentration of your specific preparation, which is why this page gives no figure.
Can I use my old instructions with a new vial?
No. Concentrations change between pharmacies and batches.
My provider sent instructions by message. Is that enough?
Ask for written instructions naming the concentration and the prescriber.
What if the label has no concentration?
Do not use it until you have that information in writing.
Why do forums give conversion charts?
Because people are trying to help. They cannot know your concentration, which is what makes those charts dangerous.
What if I have already taken too much?
Contact a poison centre or seek urgent care, especially with severe abdominal pain or persistent vomiting.
More in Compounded & Sourcing
- Compounded Tirzepatide vs Zepbound: Safety, Cost and Insurance (2026)
- What Is Actually in Compounded GLP-1 Vials
- Compounded Tirzepatide: Current Legal Status
- Red Flags in Compounded GLP-1 Sellers
- Compounded Semaglutide: What It Legally Is
- Compounded GLP-1s: What They Are and How to Check a Supplier
